Instructions for EZEAIRE Inflator / Deflater
1- EZEAIRE is simple to use. Simply unwind the unit from the reel. Place manifold at pre determined location. Standard ezeaire (for vehicles up to 131” wheel base with 4 tires) is used from the side of vehicle. Place manifold on the ground. Run blue hose around vehicle in one direction and red hose around other. Remove tire valve caps. Clip air chucks snugly on tires. Please note A & A Innovation will manfacture ezeaire systems specific to you and your vehicles individual needs.
To deflate simply turn bleeder valve until you hear air escape. When you turn bleeder off the system will balance as indicated by the pressure gauge. Bleed air until the desired pressure is where you want it to be. Close bleeder valve at desired pressure.Un clip air chucks and re wind.
To inflate simply put an air source (compressor or air storage tank) onto the inlet valve. Remove air source to let system balance (indicated by air pressure gauge) until desired pressure is met. When you meet desired pressure simply unclip air chucks and replace tire valve caps. For vechiles with multipile pressures simply bring the system up to the lower pressure, unclip the lower pressure tires (system stays charged) and continue to inflate the remaining tires to the higher pressure. Unclip and rewind on hose reel.
Do not fill above recommended tire pressure stated on tire
